b'Treating The Plug With Tek-Kote Release SystemOnce you have completed the plug andDO NOT ATTEMPT TO USE NORMAL COTTON CLOTHS AS THEY CONTAIN MOISTURE.its been sanded lacquered and polishedWipe Application Technique:you are ready to form the tool.1.Apply Tek-Kote Fast-Release to a clean Dry Wipe. Do not over-apply, the cloth mustFirst job is to clean & seal the plug usingnot be soaked or dripping.Tek-Kote Mould Cleaner and Sealer,2.Gently wipe a thin film over the mould surface covering an area of approximately 1m 2atbefore applying Tek-Kote Release agenta time. Vigorous rubbing or polishing is not required. such as Fast-Release.The film should stay wet forup to 2 minutes.Application Type: Tek-Kote Fast-Release Repeat steps 1 and 2 on the adjacent area. Ensure a good overlap with theis applied by a wipe and leave technique.previous area to provide complete coverage.The choice of cloth is important; as the3.Frequently re-apply Tek-Kote Fast-Release to the wipe to ensure it stays wet.Tek-Kote Fast-Release reacts with water,4.Repeat until mould is completely coated. the cloth must be dry. A smooth, soft cloth with a high synthetic content, such5.When dry allow 15 minutes between coats for the film to partially cure.as Kovertek Dry Wipes are advised. Repeat Steps 1-5 above for a further 3 coats (4 in total). The Tek-Kote RangeA range of Semi Permanent, Silicone free Release Agents for mould preparation, release and care.TEK-KOTE Available in 1Ltr and 5Ltr pack sizes.'