b'Mould Release and FinishingMOULD PLUG AFTER RELEASETooling System RangesSmall Mould Low Volume System *GC 200 Iso Tooling Gelcoat* 8600 TA 35 was developed for low volume moulds.Norester 6968 TA Clear Iso NPG A lower cost system 2.5 : 1 Resin to Glass Ratio8600 TA 35 Tooling ResinHigh Stiffness System **GC 206/207 Vinyl Ester Tooling GelcoatR 6842 Low shrink Vinyl Ester Clear Skin Coat ** RM 2000/50 was the 1st MEKP cure system and is stillextensively used in Marine Industry. RM 6800 TPA Vinyl Ester Clear Skin Coat 4:1 resin to Glass Ratio RM 2000/50 Tooling ResinHigh Glass Content System ***GC 206/207 Vinyl Ester Tooling GelcoatR 6842 Low shrink Vinyl Ester Clear Skin Coat *** RM 2550 was developed to improve mechanical performanceand a higher glass content gives a durable lighter weight mould. RM 6800 TPA Vinyl Ester Clear Skin Coat 2.5:1 Resin to Glass Ratio RM 2550 Tooling ResinVinyl Ester System ****GC 206/207 Vinyl Ester Tooling GelcoatR 6842 Low shrink Vinyl Ester Clear Skin Coat **** This Vinyl Ester hybrid system is ideal for heat resistance moulds for post curing up to 120 degC. Used extensively for infusion and RM 6800 TPA Vinyl Ester Clear Skin Coat marine high durability moulds. RM 3000 can replace the need for a separate skin coat to reduce cost and waste. RM 3000 Hybrid Vinyl Ester Tooling ResinGet in touch: KoverTek Limited Follow us on Facebook, X,Units 1-4 Poldermere LinkedIn and InstagramRed House LaneTel: 01604 781702 HanningtonEmail: Info@kovertek.com NorthamptonshireWeb: kovertek.com NN6 9SZ'